gmc Workshop Repair Guides

GMC Workshop Service and Repair Manuals

Glow Plug Relay > < Glow Plug - Bank 1|Page 4227
Page 1
background image

Glow Plug: Service and Repair
Glow Plug System Relearn

IMPORTANT:  The vehicle must be in operating condition before performing this procedure.

The glow plug system type learn is used to identify the correct system type (Federal or California). The scan tool will display Federal, California or Not
Learned (Engine Data List). For visual verification refer to Glow Plug Controller (Federal). The glow plug system type needs to be relearned when a new
calibration has been flash programmed in to the PCM. The relearn procedure does not need to be done to a glow plug system type after a PCM has been
replaced. The new PCM has the ability to perform an auto learn when system is not present. The Not Learned message will display on scan tool. If a
system type has not been relearned after the PCM has been flashed, a DTC P0380 will set.

1. Turn ON the ignition, with the engine OFF.
2. Use the scan tool in order to select Special Functions, Engine Output Functions and Glow Plug System Learn.
3. Activate the Glow Plug System Learn by selecting ON. After the learn function has been performed Not Learned will display on the scan tool. In

this step the scan tool is clearing the system type.

4. Use the scan tool in order to select the Special Functions menu, and select Glow Plug.
5. Activate the Glow Plug system by selecting ON. In this step the glow plug relay is now sending the identifying (signature) voltage to the PCM.
6. The PCM will now be able to identify the correct glow plug system type. For visual verification of the glow plug system, refer to Glow Plug

Controller (Federal).

7. Clear the DTC P0380.
8. Allow the PCM to power down for at least 45 seconds.
9. Turn ON the ignition leaving the engine OFF. Use the scan tool in order to verify that DTC P0380 has not reset.

10. If DTC P0380 reset, perform the following procedure:

^

Check the connections at the glow plug relay.

^

Try again to relearn the glow plug system. If the relearn fails again, refer to DTC P0380 (Federal) or DTC P0380 (California).

Glow Plug Relay > < Glow Plug - Bank 1|Page 4227