Savana 3/4 Ton Van V8-6.5L DSL Turbo VIN F (2001)
^
If you are performing the pass-through programming procedure using a notebook computer without the power cord, ensure that the internal battery
is fully charged.
After Programming A Control Module
The powertrain may operate slightly different after a control module software/calibration update. Operating the powertrain through various driving
conditions allows the control module to re-learn certain values. The control module must re-learn the following after a software/calibration update:
^
Fuel trim correction
^
Idle air control learned position
^
Automatic transmission shift adapts
Other learned values only re-learn by doing a service procedure.
If a control module is replaced the following service procedures must be performed:
^
The crankshaft variation learn procedure, if applicable.
^
The Engine Oil Life Reset Procedure, if applicable
^
The Idle Learn Procedure, if applicable
^
The Inspection/Maintenance Complete System Set Procedure
^
The Vehicle Theft Deterrent Password Learn Procedure, if applicable
^
The TP Sensor Learn Procedure, if applicable
