Savana 3/4 Ton Van V8-6.5L DSL Turbo VIN F (2001)
1. Install the glow plug relay on the mounting bracket.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the glow plug relay mounting bolt (4).
Tighten
Tighten the mounting bolt to 22 N.m (16 lb ft).
3. Install all three wiring harness connectors to the relay (1).
4. Install the glow plug battery feed nut and wire.
Tighten
Tighten the nut to 4.5 N.m (40 lb in).
5. Install the upper intake manifold cover bolts.
Tighten
Tighten the bolts to 11 N.m (98 lb in).
IMPORTANT: Ensure that the PCM electrical harness is properly routed to avoid contact with the engine cover during installation.
6. Install the engine cover.
7. Connect the negative battery cables.