Savana 3/4 Ton Van V8-6.5L DSL Turbo VIN F (2001)
Repairs and Inspections Required After a Collision: Service and Repair
Steering Column
Repair Instructions
Steering Column Accident Damage Inspection - Off Vehicle
-
Vehicles involved in accidents resulting in frame damage, major body or sheet metal damage, or where the steering column has been impacted, or
where supplemental inflatable restraint systems deployed may also have a damaged or misaligned steering column.
-
Check the capsules on the steering column bracket assembly: all must be securely seated in the bracket slots and checked for any loose conditions
when pushed or pulled by hand. If not, the bracket should be replaced if bolted to the jacket assembly. If the bracket is welded to the jacket
assembly replace the jacket assembly.
-
Check for jacket assembly collapse by measuring the distance from the lower edge of the upper jacket to a defined point on the lower jacket. If
measured dimensions are not within specifications, a new jacket must be installed.
Important: The inflatable restraint steering wheel module coil assembly must be removed from the steering column and allowed to hang freely
before shaft is rotated. Failure to do so could damage coil assembly.
-
Remove the inflatable restraint steering wheel module coil.
-
Visually inspect steering shaft for sheared injected plastic (1). If steering shaft shows sheared plastic, a new steering shaft must be installed.
-
Any frame damage that could cause a bent steering shaft must have the steering shaft runout checked in the following manner. Using a dial
indicator at the lower end of the steering shaft, have the steering wheel rotated. Runout must not exceed 1.60 mm (0.625 inch).
-
Install the inflatable restraint steering wheel module coil.
