Savana 3/4 Ton Van V8-6.5L DSL Turbo VIN F (2001)
Center Link: Service and Repair
Connecting Rod Replacement
Connecting Rod Replacement
-
Tools Required
-
J 24319-B Universal Steering Linkage Puller
-
J 29193 Steering Linkage Installer (12 mm)
Removal Procedure
Important: Use the proper tool in order to separate the ball studs.
1. Raise the vehicle. Support the vehicle with suitable safety stands.
2. Remove the prevailing torque nut (1) from the relay rod (2) ball stud at the pitman arm.
Discard the prevailing torque nut (1).
3. Use the J 24319-B in order to remove the connecting rod from the relay rod.
4. Remove the prevailing torque nut from the connecting rod ball stud at the pitman arm.
Discard the prevailing torque nut.
5. Use the J 24319-B in order to remove the connecting rod from the pitman arm.
6. Remove the connecting rod from the vehicle.
7. Inspect the ball stud threads for damage.
8. Inspect the ball stud seals for excessive wear.
9. Clean the threads on the ball stud.
Installation Procedure
