Savana 3/4 Ton Van V8-6.5L DSL Turbo VIN F (2001)
24. Shake the rear window primer (black #2) for at least 1 minute.
25. Use a new dauber, in order to apply the rear window primer (black #2) to the areas of the rear window (1) to which prep (clear #1) was applied.
26. Allow the primer to dry for approximately 10 minutes.
27. If using the short method, cut the tip of the applicator nozzle in order to provide a bead of 6.0 mm (1/4 in).
28. If using the extended method, cut the applicator nozzle in order to provide a bead 10.5 mm (0.14 in) wide and 10.5 mm (0.14 in) high.
29. Use a cartridge-type caulking gun, apply a smooth continuous bead of new urethane adhesive around the edge of the rear window where the primer
was applied.
30. When using the short method, apply the urethane adhesive to the existing bead of urethane adhesive on the body.
31. When using the extended method, use the edge of the rear window or the inside edge of the reveal molding as a guide for the nozzle in order to
apply the urethane adhesive to the inner surface of the rear window.
