Savana 3/4 Ton Van AWD V8-5.3L VIN T (2003)
4. Remove the rubber cap or plug from the exposed brake hose fitting end.
Important: Install 2 new copper brake hose gaskets.
5. Assemble the 2 new copper brake hose gaskets and the brake hose to caliper bolt to the brake hose.
6. Install the brake hose to caliper bolt to the brake caliper.
Tighten the brake hose to caliper bolt to 44 Nm (32 ft. lbs.).
7. Bleed the hydraulic brake system.
8. Install the tire and wheel assembly.
9. Lower the vehicle.
10. Fill the master cylinder reservoir to the proper level with clean brake fluid.
