Savana 3/4 Ton Van AWD V8-5.3L VIN T (2003)
Brake Caliper: Service and Repair
Brake Caliper Overhaul - Rear
Rear (15 Series)
Brake Caliper Overhaul - Rear (15 Series)
Caution:
Refer to Brake Dust Caution in Service Precautions.
See: Service Precautions/Technician Safety Information/Brake Dust Caution
Caution:
Refer to Brake Fluid Irritant Caution in Service Precautions.
See: Service Precautions/Technician Safety Information/Brake Fluid Irritant Caution
Disassembly Procedure
Important: Replace all the components included in the repair kits used to service this brake caliper.
Lubricate the rubber parts with clean brake fluid make assembly easier
The torque values specified are for dry, non lubricated fasteners.
Perform the service operations on a clean bench free from all mineral oil materials.
1. Remove the brake caliper from the vehicle.
Caution:
Do not place your fingers in front of the piston in order to catch or protect the piston while applying compressed air. This could
result in serious injury.
2. Place a thin piece wood in front of the piston in order to prevent damage. Remove the piston by directing compressed air into the brake hose inlet
fitting port of the brake caliper housing.
3. Remove the piston boot.
4. Remove the piston seal.
5. Remove the brake caliper bleed screw cap.