Savana 3500 V8-4.8L (2009)
1. Install a NEW CMP actuator magnet gasket (753) onto the CMP actuator magnet.
2. Install the CMP actuator magnet (752) to the front cover.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
3. Install the CMP actuator magnet bolts (751) and tighten to 12 Nm (106 lb in).
4. Connect the engine harness electrical connector to the CMP actuator magnet.
5. Install the water pump. Refer to Water Pump Replacement (LU3) (See: Water Pump/Service and Repair)Water Pump Replacement (LMF/LY2)
(See: Water Pump/Service and Repair)Water Pump Replacement (LMM) (See: Water Pump/Service and Repair)Water Pump Replacement
(LY6) (See: Water Pump/Service and Repair).
