Savana 3500 V8-4.8L (2009)
1. Lubricate the O-ring seal (421) with clean engine oil.
2. Install a NEW O-ring seal onto the oil level indicator tube, if required.
3. Install the oil level indicator tube (420) between the exhaust manifold and engine block.
4. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
5. Insert the oil level indicator tube into the block.
The tube must be installed with the collar flush to the block.
6. Lower the vehicle.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
7. Install the oil level indicator tube bolt (419) and tighten to 25 Nm (18 lb ft).
8. Install the oil level indicator (418).
9. Position the coolant recovery reservoir and install the retaining bolt.
10. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement (See: Tune-up and Engine Performance Checks/Air Cleaner
Housing/Service and Repair).
