gmc Workshop Repair Guides

GMC Workshop Service and Repair Manuals

Engine - Oil Leak At Oil Cooler Hose/Pipe Assembly|Page 1897 > < Engine Oil|Capacity Specifications|Page 1888
Page 1
background image

Oil Cooler: Customer Interest
Engine - Oil Leak At Oil Cooler Hose/Pipe Assembly

TECHNICAL

Bulletin No.: 08-06-02-003A

Date: October 27, 2010

Subject: Engine Oil Leak at Engine Oil Cooler Hose/Pipe Adapter to Engine Connection (Diagnose and Repair as Outlined)

Models:

2007-2011 Chevrolet Silverado, Suburban, Tahoe
2008-2011 Chevrolet Express
2007-2011 GMC Sierra, Yukon, Yukon XL
2008-2011 GMC Savana
Equipped with 4.8L, 5.3L, 6.0L or 6.2L V8 Engine (VIN Code C, M, L, J, 4, 0, 3, 5, K, Y, 8 or 2 - RPO LY2, LH6, LY5, LMF, LMG, LC9, LFA, LY6,
L76, L92 or L9H) and Engine Oil Cooling System RPO KC4 

Supercede:
This bulletin is being revised to clarify the Subject text, add model years, Cause, Correction, graphics and part number information. Please discard
Corporate Bulletin Number 08-06-02-003 (Section 06 - Engine/Propulsion System). 

Condition

Some customers may comment on an engine oil leak. Upon further investigation, the technician may find engine oil leaking from the engine oil cooler
hose/pipe adapter at the point where it connects to the engine. 
Cause

This condition may be caused by any of the following: 

-

A damaged engine oil cooler hose/pipe adapter gasket, due to a temporary steel sealing device not being removed when the engine oil cooler
hose/pipe adapter was first connected to the engine. 

-

Previous oil leak servicing of the engine oil cooler hose/pipe adapter gasket that involved failing to remove the temporary steel sealing device. 

-

Casting porosity at the engine oil cooler hose/pipe adapter bolt holes of the engine. 

-

The engine oil cooler hose/pipe adapter bolts are not torqued to the proper specification. 

Correction

1. Perform the oil leak diagnosis procedure. Refer to Oil Leak Diagnosis in SI. 
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in SI. 

3. The temporary steel sealing device (1) is shown separately from the adapter gasket (2). The temporary steel sealing device SHOULD NOT be

installed on the engine or the engine oil cooler hose/pipe adapter. 

Note

Engine - Oil Leak At Oil Cooler Hose/Pipe Assembly|Page 1897 > < Engine Oil|Capacity Specifications|Page 1888