Savana 3500 V8-4.8L (2009)
*
Position the mounting/dismounting head 180° from the valve stem.
*
Position the bead transition area 45° counterclockwise of the valve stem.
*
Using the tire machine, rotate the tire/wheel assembly clockwise when transferring the tire bead to the inside of the wheel rim.
*
Repeat items for outer bead.
4. Install the tire on the wheel. Refer to Tire Dismounting and Mounting (See: Tires/Service and Repair/Removal and Replacement).
Note: A service replacement tire pressure sensor is shipped in OFF mode. In this mode the sensor unique identification code cannot be learned
into the remote control door lock receiver (RCDLR) memory. The sensor must be taken out of OFF mode by spinning the tire/wheel assembly
above 32 km/h (20 mph) in order to close the sensors internal roll switch for at least 10 seconds.
5. Install the tire/wheel assembly on the vehicle. Refer to Tire and Wheel Removal and Installation (See: Service and Repair).
6. Lower the vehicle.
7. Learn the tire pressure sensors. Refer to Tire Pressure Indicator Sensor Learn (See: Tire Monitoring System/Service and Repair).
