Savana 3500 V8-4.8L (2009)
Wheel Fastener: Service and Repair
Front Suspension
Wheel Stud Replacement
Tools Required
J 43631 Ball Joint Remover
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Vehicle Lifting/Service and Repair).
2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation (See: Service and Repair).
3. Remove the wheel stud from the hub flange using the J 43631 .
4. Remove the wheel stud from the hub flange.
Installation Procedure
1. Install the new stud into the hub flange hole using firm hand pressure.
2. Install 4 washers to the new wheel stud.
3. Thread a wheel nut onto the new stud with the flat side facing the front hub flange.
4. Tighten the lug nut until the stud contacts the back of the hub flange.
5. Remove the wheel nut.
6. Remove the washers.
7. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation (See: Service and Repair).
8. Lower the vehicle.
