Savana 3500 V8-4.8L (2009)
1. Install the accelerator pedal assembly.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the accelerator pedal nuts and tighten to 20 Nm (15 lb ft).
3. Connect the APP sensor electrical connector.
4. Reposition the carpet.
5. Connect a scan tool in order to test for proper throttle-opening and throttle-closing range.
6. Operate the accelerator pedal and monitor the throttle angles. The accelerator pedal should operate freely, without binding, between a closed
throttle, and a wide open throttle (WOT).
7. Verify that the vehicle meets the following conditions:
*
The vehicle is not in a reduced engine power mode.
*
The ignition is ON.
*
The engine is OFF.
8. Inspect the carpet fit under the accelerator pedal.
