Savana 3500 V8-4.8L (2009)
Vehicle Speed Sensor: Service and Repair
Vehicle Speed Sensor Replacement
Removal Procedure
1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
2. Remove the electrical connector from the speed sensor.
3. Remove the bolt.
4. Remove the speed sensor and the O-ring seal.
5. Inspect the seal and the transmission case. Replace the seal, if necessary.
Installation Procedure
1. Install the speed sensor and the O-ring seal into the transmission.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the bolt and tighten to 11 Nm (97 lb in).
3. Install the electrical connector to the speed sensor.
4. Lower the vehicle.