Savana 3500 V8-4.8L (2009)
5. Connect the chassis wiring harness electrical connector (1) to the fuel pressure sensor (2).
6. Install the chassis wiring harness clip (3) to the fuel pipe.
7. Lower the vehicle.
8. Install the fuel feed and EVAP pipes to the engine compartment fuel pipes.
9. Install the fuel pipes to the retainer clip and tighten the nut to 28 Nm (21 lb ft).
10. Tighten the fuel filler cap.
11. Connect the negative battery cable. Battery Negative Cable Disconnection and Connection (See: Starting and Charging/Battery/Battery
Cable/Service and Repair).
12. Inspect for leaks:
1. Turn ON the ignition for 2 seconds.
2. Turn OFF the ignition for 10 seconds.
3. Turn ON the ignition.
4. Inspect for fuel leaks.
13. Install the engine cover. Refer to Engine Cover Replacement (See: Body and Frame/Access Cover/Service and Repair).