Savana 3500 V8-4.8L (2009)
Fuel Hose/Pipes Assembly Replacement (Cutaway Van Side Tank)
Removal Procedure
Warning: Refer to Battery Disconnect Warning (See: Starting and Charging/Battery/Service Precautions).
1. Disconnect the negative battery cable.
2. Clean all the fuel pipe and hose connections and the surrounding areas before disconnecting in order to avoid possible contamination of the fuel
system.
3. Remove the fuel filler cap.
4. Drain the fuel below the level of the fuel tank fill hose. Refer to Fuel Tank Draining (with L59) (See: Fuel Tank/Service and Repair)Fuel Tank
Draining (without L59) (See: Fuel Tank/Service and Repair).
5. Raise the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
6. Loosen the fuel fill hose clamps (2, 3).
7. Remove the fuel fill hose (6).
8. Cap the open end of the fuel tank.
Installation Procedure
1. Uncap the fuel tank.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the fuel fill hose (6) and tighten the fuel fill hose clamps (2, 3) to 2.75 Nm (24 lb in).
3. Lower the vehicle.
4. Refill the fuel tank.
5. Install the fuel filler cap.
6. Connect the negative battery cable.
Fuel Hose/Pipes Assembly Replacement (Passenger/Cargo Van Fuel Tank Pipes)
Fuel Hose/Pipes Assembly Replacement (Passenger/Cargo Van Fuel Tank Pipes)
Removal Procedure
