Savana 3500 V8-4.8L (2009)
Note: The TPA cannot be removed from the connector while there are terminals present in the connector body.
3. Use a small flat-blade tool to push the TPA until it bottoms out.
4. Use the J 38125-28 tool to release the terminals by inserting the tool into the terminal cavity as shown in the graphic. See the release tool cross
reference in the Reference Guide of the J-38125 to ensure that the correct release tool is used.
5. While holding the removal tool in place, gently pull the wire out of the back of the connector. Always remember never use force when pulling a
terminal out of a connector.
Repair Procedure
Use the appropriate terminal and follow the instructions in the J-38125 .
Location of the terminal in the repair tray and the proper crimp tool can be found in the appropriate connector end view.
Terminal Replacement Procedure
