gmc Workshop Repair Guides

GMC Workshop Service and Repair Manuals

4L60-E/4L65-E/4L70-E - Automatic Transmission|Page 4799 > < 4L60-E/4L65-E/4L70-E - Automatic Transmission|Page 4794
Page 1
background image

Extension Housing: Service and Repair
4L60-E/4L65-E/4L70-E - Automatic Transmission

Case Extension Assembly Replacement

Removal Procedure

1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle   (See: Maintenance/Vehicle Lifting/Service and Repair).
2. Support the transmission with a transmission jack.
3. Place a drain pan under the vehicle.
4. Remove the propeller shaft. Refer to One-Piece Propeller Shaft Replacement   (See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller

Shaft/Service and Repair/One-Piece Propeller Shaft Replacement) or Two-Piece Propeller Shaft Replacement   (See: Drive/Propeller Shafts,
Bearings and Joints/Drive/Propeller Shaft/Service and Repair/Two-Piece Propeller Shaft Replacement).

5. Remove the transmission mount. Refer to Transmission Mount Replacement   (See: Transmission Mount/Service and

Repair/4L60-E/4L65-E/4L70-E - Automatic Transmission).

6. Remove the case extension bolts (1).
7. Remove the case extension (2).
8. Remove and discard the case extension O-ring seal (3).

Installation Procedure

1. Install a new case extension O-ring seal (3).
2. Install the case extension (2).

Caution:  Refer to Fastener Caution   (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).

3. Install the case extension bolts (1) and tighten to 45 Nm (33 lb ft).
4. Install the transmission mount. Refer to Transmission Mount Replacement   (See: Transmission Mount/Service and

Repair/4L60-E/4L65-E/4L70-E - Automatic Transmission).

5. Install the propeller shaft. Refer to One-Piece Propeller Shaft Replacement   (See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller

Shaft/Service and Repair/One-Piece Propeller Shaft Replacement) or Two-Piece Propeller Shaft Replacement   (See: Drive/Propeller Shafts,
Bearings and Joints/Drive/Propeller Shaft/Service and Repair/Two-Piece Propeller Shaft Replacement). 

6. Remove the drain pan and the transmission jack.
7. Lower the vehicle.
8. Fill the transmission to the proper level with DEXRON(R) VI transmission fluid. Refer to Transmission Fluid Check   (See: Testing and

Inspection/Component Tests and General Diagnostics/4L60-E/4L65-E/4L70-E - Automatic Transmission/Transmission Fluid Check).

4L60-E/4L65-E/4L70-E - Automatic Transmission|Page 4799 > < 4L60-E/4L65-E/4L70-E - Automatic Transmission|Page 4794