Savana 3500 V8-4.8L (2009)
each repair.
With the ATF in a tightly sealed container, place the container in a tub of hot water for a period of time. Then pour the ATF into the reservoir. This
method works best with a low fluid level in the reservoir.
Place the Transflow(R) machine in the direct sunlight with the cabinet door open to expose the reservoir to the rays of the warm sun.
Flush / Flow Test Procedure
Important
All labor operations that include removal of the transmission from the vehicle and require the transmission oil pan or transmission side cover to
be removed include labor time to flush the transmission oil cooler system.
Refer to SI for Automatic Transmission Oil Cooler Flushing and Flow Test J 45096 for the appropriate procedure.
Important
The J 45096 can be used to flush the transmission oil cooler system on an Allison equipped vehicle, but the flow meter should not be utilized.
Refer to SI for Automatic Transmission Oil Cooler Flushing and Flow Test J 45096 for the appropriate flow check procedure.
Machine Displays
After completion of the flush and flow test, the following information is to be recorded on the repair order. This information is displayed on the
Transmission Cooling System Service Tool, J 45096, Transflow(R) machine when the dial is in the code position.
-
Tested flow rate (displayed in Gallons Per Minute (GPM)
-
Temperature (displayed is degrees Fahrenheit)
-
Cycle number (a number)
-
Seven digit Alpha/Numeric flow code (i.e. A10DFB2)
Warranty Information
Important
All labor operations that include removal of the transmission from the vehicle include labor time to flush the transmission oil cooler system.
Performing a transmission oil cooling system flush and flow test will use between 4.7-7.5 L (5-8 qts) of DEXRON(R)VI transmission fluid. The amount
