Savana 3500 V8-4.8L (2009)
1. If replacing the lower inner shaft housing bushing, install the inner shaft housing bushing bore into a vise.
2. Place the lower inner shaft housing bushing over the bushing bore.
3. Install the J 45850-2 (2), J 45850-1 (3), the forcing screw, the thrust bearing, the washers, and the nuts (1) over the inner shaft housing bushing as
shown.
Install the J 45850-3 inside the J 45850-2 (2) in order to gain access to the upper nut.
4. Install the lower inner shaft bushing by holding the lower nut and slowly tightening the upper nut in order to pull the bushing into the bushing bore.
5. If replacing the upper inner shaft housing bushing, install the inner shaft housing bushing bore into a vise.
6. Place the upper inner shaft housing bushing over the bushing bore.
7. Install the J 45850-2 (2), J 45850-1 (3), the forcing screw, the thrust bearing, the washers, and the nuts (1) over the inner shaft housing bushing as
shown.
Install the J 45850-3 inside the J 45850-2 (2) in order to gain access to the upper nut.
8. Install the upper inner shaft bushing by holding the lower nut and slowly tightening the upper nut in order to pull the bushing into the bushing bore.
9. Remove the inner shaft housing from the vise.
10. Install the inner shaft housing. Refer to Front Drive Axle Inner Shaft and Inner Shaft Housing Replacement (See: Service and Repair/Removal
and Replacement/Front Drive Axle/Front Drive Axle Inner Shaft and Inner Shaft Housing Replacement).