Savana 3500 V8-4.8L (2009)
7. Install the J 8614-2 (2) and the J 8614-3 (3) into the J 8614-01 (1) as shown.
8. Remove the pinion yoke by turning the J 8614-3 (3) clockwise while holding the J 8614-01 (1).
Use a container in order to retrieve the lubricant.
9. Remove the pinion oil seal using a suitable seal removal tool.
Installation Procedure
1. Install the new seal using the J 45710 .
2. Install the pinion yoke.
Caution: Refer to Pinion Flange/Yoke Installation Caution (See: Service Precautions/Pinion Flange/Yoke Installation Caution).
3. Seat the pinion yoke onto the pinion shaft by tapping it with a soft-faced hammer until a few pinion shaft threads show through the yoke.
