Savana 3500 V8-6.0L (2007)
Engine Mount: Service and Repair
Engine Mount Replacement - Right
Engine Mount Replacement - Right Side
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the starter.
3. Remove the right side exhaust manifold.
4. Remove the engine mount to the frame mounting bolts.
Notice: When raising or supporting the engine for any reason, do not use a jack under the oil pan, any sheet metal, or crankshaft balancer. Jacking
against the oil pan may cause it to crack or break.
Important: Raise the engine only enough to permit removal of the engine mount.
5. Raise and suitably support the engine using adjustable (screw type) jackstands.
6. Remove the engine mount to the engine mounting bolts.
7. Remove the engine mount from the vehicle.
Installation Procedure
1. Install the engine mount to the vehicle.
Notice: Refer to Fastener Notice.
2. Install the engine mount to the engine mounting bolts.
Tighten the engine mount to engine mounting bolts to 50 N.m (37 lb ft).
