Savana 3500 V8-6.0L (2007)
Torque Converter Clutch Solenoid: Service and Repair
Torque Converter Clutch Pulse Width Modulation Solenoid, Torque Converter Clutch Solenoid, and Wiring Harness
Tools Required
J 28458 Seal Protector Retainer Installer
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the transmission oil pan and the filter.
3. Disconnect the transmission harness 20-way connector from the transmission internal harness pass-through connector.
Depress both tabs on the connector and pull straight up; do not pry the connector.
Important: Removal of the valve body is not necessary for the following procedure.
4. Remove the 1-2 accumulator assembly. Do not remove the spacer plate.
5. Disconnect the internal wiring harness electrical connectors from the following components:
*
Transmission fluid pressure switch (1)
*
1-2 shift control solenoid (2)
*
2-3 shift control solenoid (3)
*
Pressure control solenoid (4)
*
TCC PWM solenoid (5)
*
3-2 control solenoid (6)