Savana 3500 V8-6.6L DSL Turbo (2009)
Front Crankshaft Seal: Service and Repair
Crankshaft Front Oil Seal Replacement
Special Tools
*
J 44644 Crankshaft Front Oil Seal Remover
*
J 44645 Crankshaft Front Oil Seal Installer
Removal Procedure
1. Remove the crankshaft balancer. Refer to Crankshaft Balancer Replacement (See: Cylinder Block Assembly/Harmonic Balancer - Crankshaft
Pulley/Service and Repair/Crankshaft Balancer Replacement).
2. Install the button of J 44644 into the crankshaft.
3. Press the jaws of J 44644 into the felt portion of the seal far enough to engage the inner lip of the seal.
4. While holding the jaws of J 44644 tightly to the seals inner sleeve, tighten the jaw bolts.
5. Using the J 44644 , remove the crankshaft front oil seal.
Installation Procedure
