Savana 3500 V8-6.6L DSL Turbo VIN 2 (2006)
Rear Door Weatherstrip: Service and Repair
Sealing Strip Replacement - Outer Belt
Sealing Strip Replacement - Outer Belt
Removal Procedure
1. Lower the window.
2. Tilt the top of the sealing strip away from the vehicle in an outboard direction.
3. Gently pull the sealing strip away from the pinch weld flange.
Installation Procedure
1. Spray the inside of the sealing strip with a water and soap solution.
2. Install the sealing strip to the pinch-weld flange by tilting the top edge of the sealing strip slightly outboard to ensure the pinch weld flange
correctly enters the retention clips.
3. Push down on sealing strip until all clips are fully seated.
4. Raise the window.
Weatherstrip Replacement - Left Rear Door - Lower
Weatherstrip Replacement - Left Rear Door - Lower
Removal Procedure
1. Remove the left rear door weatherstrip from the left rear door.
2. Remove the left rear door weatherstrip retainers from the left rear door.
Installation Procedure