Savana 3500 V8-6.6L DSL Turbo VIN 2 (2006)
8. Important:
Install 2 NEW copper brake hose gaskets.
Assemble the 2 NEW copper brake hose gaskets and the brake hose to caliper bolt to the brake hose.
9. Connect the brake hose at the caliper by installing the brake hose to caliper bolt.
^
Tighten the brake hose to caliper bolt to 40 Nm (30 ft. lbs.).
10. Bleed the hydraulic brake system.
11. Install the tire and wheel assembly.
12. Lower the vehicle.
13. Fill the master cylinder reservoir to the proper level with clean brake fluid.
Disc Brake Hardware Replacement - Front
Disc Brake Hardware Replacement - Front
Caution: Refer to Brake Dust Caution in Service Precautions.
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the tire and wheel assembly.
3. Notice:
Support the brake caliper with heavy mechanic's wire, or equivalent, whenever it is separated from its mount and the hydraulic flexible brake hose
is still connected. Failure to support the caliper in this manner will cause the flexible brake hose to bear the weight of the caliper, which may cause
damage to the brake hose and in turn may cause a brake fluid leak.
Remove the caliper from the mounting bracket and support the caliper with heavy mechanic's wire or equivalent. DO NOT disconnect the
hydraulic brake flexible hose from the caliper.
4. Remove the disc brake pads from the disc brake caliper mounting bracket.
5. Remove the disc brake pad retainers from the disc brake caliper mounting bracket.
6. Inspect the disc brake hardware.
