Savana 3500 V8-6.6L DSL Turbo VIN 2 (2006)
5. Remove the evaporator outlet hose retaining nuts (4, 5).
6. Remove the retaining nut (3) from the evaporator inlet tube (5).
7. Remove the evaporator inlet tube from the evaporator.
8. Remove the sealing washers.
9. Remove the screws (2) from the evaporator and blower module assembly.
10. Remove the evaporator and blower module assembly front cover (3).
11. Remove the recirculation door actuator (7) and the linkage.
INSTALLATION PROCEDURE
1. Install the recirculation door actuator (7) and the linkage.
2. Install the evaporator and blower module assembly cover (3).
3. Install the screws.
Tighten the screws to 1.9 N.m (17 lb in).
NOTE: Refer to Fastener Notice in Service Precautions.
4. Install new sealing washers to the evaporator inlet and outlet tubes.