Savana 3500 V8-6.6L DSL Turbo VIN 2 (2006)
Blower Motor Resistor: Service and Repair
Blower Motor Resistor Assembly - Auxiliary
BLOWER MOTOR RESISTOR ASSEMBLY REPLACEMENT - AUXILIARY
REMOVAL PROCEDURE
1. Remove the left rear quarter trim panels.
2. Disconnect the electrical connector from the blower motor resistor.
3. Remove the retaining screws.
4. Remove the blower motor resistor from the blower case.
INSTALLATION PROCEDURE
1. Install the blower motor resistor into the blower case.
2. Install the retaining screws to the blower case.
Tighten the screws to 2 N.m (18 lb in).
NOTE: Refer to Fastener Notice in Service Precautions.
3. Connect the electrical connector to the blower motor resistor.
4. Install the left rear quarter trim panels.
