Savana 3500 V8-6.6L DSL Turbo VIN 2 (2006)
Route the hose in the same position the hose occupied prior to removal.
2. Notice:
Refer to Fastener Notice in Service Precautions.
Install the power brake booster inlet hose (1) to the power brake booster (2).
Tighten the hose fitting to 33 Nm (24 ft. lbs.).
3. Raise the vehicle.
4. Install the power brake booster inlet hose (2) to the power steering pump (1) through the wheel well.
Tighten the hose fitting to 33 Nm (24 ft. lbs.).
5. Install the tire and wheel.
6. Lower the vehicle.
7. Bleed the power steering system. Refer to Bleeding the Power Steering System.
8. Remove the drain pan from under the vehicle.
