Savana 3500 V8-6.6L DSL Turbo VIN 2 (2006)
1. Install the fuel rail and bracket.
NOTE: Refer to Fastener Notice.
2. Install the fuel rail bolts.
Tighten the bolts to 25 N.m (18 lb ft).
3. Install the fuel injector pipes.
NOTE: Ensure proper torquing of the fuel injector line. An under-torqued fuel injector line will not seal properly and an over-torqued fuel injector
line may damage the fuel injector fitting. An improperly sealed or damaged fuel injector line or fuel injector fitting will cause a fuel leak.
Tighten the fittings to 41 N.m (30 lb ft).
4. After installing the fuel injector pipes, clean the injector pipes and apply sealant GM P/N 97720043, at the fittings to prevent moisture and debris
from collecting between the line and fitting.
