Savana 3500 V8-6.6L DSL Turbo VIN 2 (2006)
10. Remove the fuel bundle nuts from the chassis.
11. Loosen the electronic brake control module (EBCM) bracket bolts (4).
12. Allow the EBCM to remain loose in order to allow fuel pipe clearance.
13. Remove the fuel bundle using the following procedure:
1. Guide the fuel bundle pipes towards the rear of vehicle to clear the engine.
2. Lower the fuel bundle while moving it foreword and out.
INSTALLATION PROCEDURE
1. Install the fuel pipe bundle using the following procedure:
1. Install the fuel bundle to the chassis by guiding the pipes towards the rear of vehicle.
2. Lift the fuel pipes, while guiding the forward portion of the pipes up towards the engine connections.
2. Install the fuel bundle nuts to the chassis.
NOTE: Refer to Fastener Notice.
Tighten the nuts to 16 N.m (12 lb ft).
