Savana 3500 V8-6.6L DSL Turbo VIN 2 (2006)
Tighten the nut to 21 N.m (15 lb ft).
10. Connect the fuel lines.
11. Install the glow plug module, if removed.
12. Install the auxiliary generator, if removed.
13. Remove the tape from the turbocharger openings.
IMPORTANT: Lubricate the end of the duct prior to installation.
14. Install the charged air cooler inlet duct connector (4) to the turbocharger.
15. Tighten the charged air cooler inlet duct connector to turbocharger clamp (1).
Tighten the clamp to 6 N.m (53 lb in).
16. Fill the cooling system. Refer to Draining and Filling Cooling System (Static Fill) Draining and Filling Cooling System (Vac N Fill). See: Engine,
Cooling and Exhaust/Cooling System/Service and Repair
17. Connect the negative battery cable.
18. Prime the fuel system. Refer to Fuel System Priming.
19. Start the engine. If the engine stalls, repeat the above step.
20. Once the engine starts, inspect for fuel leaks.
21. Install the engine cover.
Fuel Injector Feed Pipes Replacement - Right
FUEL INJECTOR FEED PIPES REPLACEMENT - RIGHT
