Savana 3500 V8-6.6L DSL Turbo VIN 2 (2006)
Installation Procedure
Important: The crankshaft reluctor and the oil pump drive gear are timed at the factory. In order to re-establish proper timing, install knock pins
in the oil pump drive gear if the crankshaft reluctor was removed from the oil pump drive gear. The knock pins are available through the parts
department.
1. Install the knock pins in the oil pump drive gear to a height of 4.5 - 5.5 mm (0.177 - 0.217 inch).
2. Install the crankshaft reluctor on the oil pump drive gear. Ensure the reluctor is aligned on the knock pins.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the crankshaft reluctor bolts.
Tighten the bolts to 8 Nm (71 inch lbs.).
Important: Do not damage the teeth on the crankshaft reluctor.
4. Install the oil pump drive gear and reluctor to the crankshaft.
