Savana 3500 V8-6.6L DSL Turbo VIN 2 (2006)
deployment harness.
25. Strip 13 mm (0.5 in) of insulation from both ends of the wires cut in the previous step.
26. Twist together one end from each of the wires in order to short the wires.
27. Twist together two connector wire leads, the high circuits from both stages of the I/P module, to one set of deployment wires. Refer to SIR
Connector End Views in order to determine the correct circuits.
28. Inspect that the connection is secure.
29. Bend flat the twisted connection.
30. Secure and insulate the connection using electrical tape.
31. Twist together two connector wire leads, the low circuits from both stages of the I/P module, to one set of deployment wires. Refer to SIR
Connector End Views in order to determine the correct circuits.
32. Inspect that the connection is secure.
33. Bend flat the twisted connection.
