Savana 3500 V8-6.6L DSL Turbo VIN 2 (2006)
3. Raise the vehicle.
4. Install the power brake booster inlet hose (2) to the power steering pump (1) through the wheel well.
Tighten the hose fitting to 33 Nm (24 ft. lbs.).
5. Install the tire and wheel.
6. Lower the vehicle.
7. Bleed the power steering system. Refer to Bleeding the Power Steering System.
8. Remove the drain pan from under the vehicle.
Power Brake Booster Outlet Hose Replacement
Power Brake Booster Outlet Hose Replacement
Removal Procedure
1. Notice:
Refer to Power Steering Hose Disconnected Notice in Service Precautions.
Install a drain pan under the vehicle.
2. Siphon the power steering fluid from the reservoir to prevent excessive spillage.
3. Remove the power brake booster outlet hose (1) from the power brake booster (2).
4. Raise and support the vehicle. Refer to Vehicle Lifting.