Savana 3500 V8-6.6L DSL Turbo VIN 6 (2007)
Rear Door Hinge: Service and Repair
Rear Door Hinge Replacement
Rear Door Hinge Replacement
Removal Procedure
1. Remove the door from the vehicle.
2. Remove the sealer that surrounds the hinge.
3. Scribe the location of the existing hinges on the body pillar or the door.
4. Mark the approximate centers of the mig welds on the hinge base.
5. Drill a 3 mm (1/8 in) pilot hole (5) completely through the spot welds (4) at each center punch mark.
6. Drill a 13 mm (1/2 in) hole through the hinge base (6) and the body pillar or the door using the smaller hole as a pilot.
7. A small amount of weld may still retain the hinge base to the body pillar or the door. Drive a chisel between the hinge base and the body pillar or
the door in order to separate the hinge from the body pillar or the door.
