Savana 3500 V8-6.6L DSL Turbo VIN 6 (2007)
1. Install the PCP (2) into the vehicle.
Notice: Refer to Fastener Notice.
2. Install the PCP front and side mounting bracket bolts (1, 3).
Tighten the bolts to 20 N.m (15 lb ft).
3. Connect the engine wiring harness to the PCP bracket.
4. Connect the PCP electrical connector (4) to the vehicle connector harness.
5. Remove the cap or plug from the outlet pipe and install the outlet pipe to the PCP (5).
Tighten the brake fluid outlet pipe nut to 25 N.m (18 lb ft).
6. Install the inlet hose (4) and clamp (3) to the PCP (2).
7. Remove the crimping tool from the inlet hose.
8. Install the inner fender splash shield.
9. Install the left front wheel and tire.
10. Connect the negative battery cable.
11. Fill the master cylinder reservoir.
12. Using a scan tool, perform a PCP bleed procedure.
