Savana 3500 V8-6.6L DSL Turbo VIN 6 (2007)
3. Remove the anti-rattle clips from the brake caliper bracket.
4. Remove the brake caliper bracket mounting bolts (2).
5. Remove the brake caliper bracket (1).
6. Remove any contaminants or foreign material from the inside ends of the brake caliper bracket.
7. Clean the mounting surface and threads of the brake caliper bracket.
Installation Procedure
1. Install the brake caliper bracket (1).
2. Perform the following procedure before installing the brake caliper bracket mounting bolts.
^
Remove all traces of the original adhesive patch.
^
Clean the threads of the bolt with denatured alcohol or equivalent and allow to dry.
^
Apply Threadlocker GM P/N 12345493 (Canadian P/N 10953488).
Notice: Refer to Fastener Notice.
3. Install the caliper bracket mounting bolts (2).
^
Tighten the brake caliper bracket to knuckle bolt to 175 N.m (121 lb ft) for the 15 Series.
^
Tighten the brake caliper bracket to knuckle bolts to 300 N.m (221 lb ft) for 25/35 Series.
4. Install the anti-rattle clips to the brake caliper bracket.
5. Install the brake pads to the brake caliper bracket.
6. Slide the brake pads in until they contact the rotor.
7. Install the brake caliper.
8. Install the tire and wheel assembly.
9. Lower the vehicle.
