Savana 3500 V8-6.6L DSL Turbo VIN 6 (2007)
18. Install the transmission tube support nut at the bell housing.
Tighten the nut to 25 N.m (18 lb ft).
19. Install the injector wire harness stud at the center lower right cylinder head.
20. Install the EGR heater inlet hose/pipe retainer nut at the center of the lower right cylinder head.
21. Install the EGR heater inlet hose/pipe retainer stud at the rear of the engine.
Tighten the stud to N.m ( lb ft).
22. Connect the engine harness electrical connectors to the fuel injectors.