Savana 3500 V8-6.6L DSL Turbo VIN 6 (2007)
Installation Procedure
Notice: Refer to Fastener Notice.
1. Install the turbocharger vane position sensor to the turbocharger.
Tighten the sensor to 28 N.m (21 lb ft).
2. Install the turbocharger vane position sensor connector to the bracket located on the LH valve cover.
3. Connect the turbocharger vane position sensor electrical connector.
4. Install the thermal reflective shield/tape, refer to the following procedure.
Thermal Reflective Shield/Tape Installation
