Savana 3500 V8-6.6L DSL Turbo VIN 6 (2007)
1. Install a NEW copper washer to the fuel injector bore.
2. Install a NEW fuel injector O-ring to the injector.
Notice: Refer to Fastener Notice.
3. Install the fuel pressure regulator bracket nut and bolt.
Tighten the bracket bolt and nut to 10 N.m (89 lb in).
4. Install the upper right valve cover.
5. If the fuel injectors were replaced, Refer to Fuel Injector Flow Rate Programming. See: Testing and Inspection/Programming and Relearning
6. Prime the fuel system. Refer to Fuel System Priming.
7. Start the engine. If the engine stalls, repeat the above step.
8. Once the engine starts, inspect for fuel leaks.
9. Install the engine cover.
