Savana 3500 V8-6.6L DSL Turbo VIN 6 (2007)
Glow Plug: Service and Repair
Glow Plug Replacement - Bank 1
Glow Plug Replacement - Bank 1
Removal Procedure
1. Remove the engine cover.
2. Disconnect the negative battery cable.
3. If necessary, remove the left front wheel and tire.
4. Remove the engine splash shield.
5. Remove the glow plug harness nut(s).
6. Remove the harness from the glow plug(s).
7. Remove the glow plug(s).
Installation Procedure
Notice: Refer to Fastener Notice.
1. Install the glow plug(s).
Tighten the plug to 18 N.m (13 lb ft).
2. Install the harness to the glow plug(s).
3. Install the glow plug harness nut(s).
Tighten the nut to 1.7 N.m (15 lb in).