Savana 3500 V8-6.6L DSL Turbo VIN 6 (2007)
3. E-mail copies of the digital pictures to [email protected]. In the subject line of the E-mail include the phrase "Duramax(TM) diesel", the
complete VIN and Dealer BAC. In the body of the E-mail include the VIN, mileage, R.O. number and BAC. Include a brief description of the
customer concern and cause of the concern.
Note
The dealer will receive an email reply after the calibrations have been validated. The email reply will advise the dealer if the calibrations are
OEM.
4. Allow two hours for the PQC to verify the calibrations and set up the case details.
‹› If the PQC determines that the calibrations ARE aftermarket calibrations, DO NOT contact GM Technical Assistance to discuss warranty
concerns on the aftermarket calibrations. ALL questions and concerns about warranty should be directed to the dealers Fixed Operations
Manager (FOM), (Warranty Manager (WM) in Canada).
5. You may call the PQC two hours after submitting the required information for authorization to replace the assembly. This will provide them
time to receive, review the information and set up a case on the request. Be prepared to provide all of the usual documentation that is normally
required when requesting an assembly authorization from the PQC.
2007-2011 RPO LMM Instructions for Tech 2 Transmission Data Path - Power-up Hardware Detection
Transmission Data ONLY Available With GMC Sierra, TopKick, Chevrolet Kodiak, Silverado
An example of this hardware is a propane injection system.
A transmission control module (TCM) algorithm has been implemented that records a maximum calculated input torque. This information is available
via the Tech 2(R).
1. Build the vehicle with the Tech 2(R).
2. Select F3: Transmission Control Module
3. Select F1: Data Display
4. Select F0: Transmission Data
5. Highlight: Max Transmission Calc Engine Torque
Transmission Data Screen (Max. Trans Calc. Engine Torque Parameter)
6. Take a clear digital picture of the Tech 2(R) screen showing the Transmission Data and the Max Transmission Calc Engine Torque parameter.
7. Retain the Tech 2(R) Transmission Data screen photograph with the repair order.
Warranty Information
-
The Dealership Service Management must be involved in any situation that would justify the use of labor operation Z1111.
-
Notify the Fixed Operations Manager (FOM) (Warranty Manager (WM) in Canada) of the situation.
-
All claims will have to be routed to the FOM (WM in Canada) for approval.
-
Please refer to Corporate Bulletin Number 09-00-89-016, Labor Operation Z1111 - Suspected Tampering or Vehicle Modifications for important
information.
For vehicles repaired under warranty, use the table.