Savana 3500 V8-6.6L DSL Turbo VIN 6 (2007)
1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
Important: This procedure is for 2WD vehicles. If the vehicle is equipped with 4WD, the output speed sensor is located on the transfer
case.
2. Disconnect the output speed sensor (2) electrical connector.
3. Remove the output speed sensor bolt.
4. Remove the output speed sensor (2) and the bracket assembly from the case.
5. Inspect the output speed sensor assembly (2) for any evidence of damage.
Installation Procedure
1. Lubricate the output speed sensor seal with automatic transmission fluid.
2. Install the output speed sensor (2) and the bracket assembly.
Notice: Refer to Fastener Notice .
3. Install the bolt.
Tighten the bolt to 11 N.m (96 lb in).
4. Connect the output speed sensor electrical connector.
5. Lower the vehicle.
