Savana 3500 V8-6.6L DSL Turbo VIN 6 (2007)
2. Install the power brake booster outlet hose (1) to the power brake booster (2). Hand tighten.
3. Raise the vehicle.
4. Through the wheel well, connect the power brake booster outlet hose to the power steering gear (2).
Tighten the hose fitting to 33 N.m (24 lb ft).
5. Lower the vehicle.
6. Tighten the power brake booster outlet hose at the power brake booster.
Tighten the hose fitting to 33 N.m (24 lb ft).
7. Install the water deflector to the fender.
8. Bleed the power steering system. Refer to Power Steering System Bleeding .
9. Remove the drain pan from under the vehicle.
Power Steering Reservoir Inlet Pipe/Hose Replacement
Power Steering Reservoir Inlet Pipe/Hose Replacement
Removal Procedure
Notice: Refer to Power Steering Hose Disconnected Notice .
1. Install a drain pan under the vehicle.
