Savana 3500 V8-6.6L DSL Turbo VIN 6 (2007)
17. Install the steering shaft assembly with the tilt head assembly (1) into the steering column jacket assembly (2).
18. Maneuver the tilt lever and push the tilt head assembly (1) up towards the steering column in order to lock the steering wheel lock shoes in place.
19. Lubricate the pivot pins (1) with GM P/N 12346293 (Canadian P/N 992723).
20. Firmly seat each pivot pin (1) into the tilt head assembly.
21. Stake the steering column support assembly in the 3 locations around each pivot pin.
22. Install the adapter and bearing assembly (1) onto the steering column jacket assembly by performing the following procedure:
1. Align the tab on the adapter and bearing assembly (1) with the slot in the steering column jacket assembly.
2. Push the adapter and bearing assembly (1) onto the steering shaft assembly until the tab snaps into the slot.
23. Install the shaft seal retainer (2) onto the adapter and bearing assembly (1).
1. Align the slots of the shaft seal retainer (2) to the ribs of the adapter and bearing assembly (1).
2. Push the shaft seal retainer (2) onto the steering shaft assembly so that the retainer (2) contacts the adapter and bearing assembly (1).
24. Install the steering shaft seal (3) onto the steering shaft assembly.
25. Install the inner boot seal (4) onto the steering shaft assembly.
26. Install the linear shift assembly.
