Savana 3500 V8-6.6L DSL Turbo VIN 6 (2007)
Important: Do NOT remove the tape on the park lock cable. If the tape is removed from the park lock cable, you MUST order a new
linear shift assembly.
6. Insert a small screwdriver into the slot on the ignition lock cylinder case and push against the locking tab to remove the park lock cable assembly
(1).
7. Remove the 3 flat-head 6-lobed socket tap screws from the linear shift assembly.
8. Remove the linear shift assembly.
Installation Procedure
Notice: Refer to Fastener Notice .
Important: Do NOT remove the tape on the park lock cable. If so, the linear shift assembly MUST be replaced.
1. Install the linear shift assembly and secure by using 3 flat-head 6-lobed socket tap screws.
The linear shift assembly must be out of the PARK position to install the lower socket tap screw.
Tighten the screws to 10 N.m (89 lb in).
