Savana 3500 V8-6.6L DSL Turbo VIN 6 (2007)
Important: If the steering wheel has steering wheel controls, the inflatable restraint steering wheel module coil and the wire harness
assembly must come off as one piece. Refer to Inflatable Restraint Steering Wheel Module Coil Replacement .
8. Disconnect all connectors attached to the wire harness assembly.
Installation Procedure
1. If the steering wheel has steering wheel controls, install the inflatable restraint steering wheel module coil. Refer to Inflatable Restraint Steering
Wheel Module Coil Replacement .
2. Connect all of the connectors from the new wire harness assembly.
3. Push the key alarm connector (1) into the ignition lock cylinder case assembly (2).
4. Rotate the key alarm connector (1) 90 degrees so that the key alarm connector (1) locks into place.
Caution: Refer to SIR Inflator Module Coil Caution .
5. Install the wires back into the ignition switch clip, which is located on the side of the ignition switch.
