Savana 3500 V8-6.6L DSL Turbo VIN 6 (2007)
Caution: The tilt spring and the spring guide are under pressure. The tilt spring and the spring guide may become a projectile. Secure the
spring with locking pliers during removal. Secure the spring with locking pliers during installation. Bodily injury may result during
removal and installation of the tilt spring and the spring guide. Always use caution during removal and installation of the tilt spring and
the spring guide.
3. Install the tilt spring (1) onto the steering column support assembly (2) and onto the steering column tilt head assembly by using the following
procedure:
1. Install the tilt spring (1) onto the steering column tilt head assembly.
2. Install the tilt spring (1) onto the post on the steering column support assembly (2).
4. Install the upper and lower trim covers.
5. Enable the SIR system. Refer to SIR Disabling and Enabling .
Turn Signal Cancel Cam and Upper Bearing Thrust Washer
Turn Signal Cancel Cam and Upper Bearing Thrust Washer
Tools Required
*
J 23653-SIR Steering Column Lock Plate Compressor
*
J 42137 Cam Orientation Plate Adapter
Removal Procedure
Caution: Refer to SIR Caution .
1. Disable the SIR system. Refer to SIR Disabling and Enabling .
Important: Let the SIR coil hang freely after removal.
2. Remove the SIR coil.
3. Remove and discard the bearing retainer using J 23653-SIR and J 42137 .
